|
"Frag
0ps"
Work
log.
<Discussion>
Case
when purchased:
Getting
started:
 
Bondo/Sanding
Bondo:
Bondo is annoying and difficult
- it gets no pics! >:/
I used the bondo to fill the gap with the closet flange
and the faceplate. Also used to fill in the holes on
the side of the case under the window. I cut the back
92mm exhaust hole way to large, so had to use bondo
to make the hole smaller. To do so I used a dead 92mm
fan, ripped it apart for it's casing and used that for
a template.
Primer
Stage:
 
PSU:
Cage made, painted, shortened all the wires (cut
off extras), UV laser LED inside.
Done!
I cannot say I'm super pleased
with the paint. This was my first attempt at painting
and I probably will never do it again. I can see myslef
in it, but it could have been better.
Specs:
-Shuttle MN31N motherboard
- Dual channel RAM @ 333FSB. NVIDIA SoundStorm audio.
-Crucial PC2700 RAM (2x256) 333FSB.
-AMD XP2500 - Overclocked to 2.14Ghz
-NVIDIA eVGA 6800GT 256MB RAM DDR3. @ 380 x 1.10Ghz
-WD 40GB 8mb Hard Drive.
-420W ThermalTake PSU
-Memorex DVD/CDRW
-6-in-1 card reader (USB 2.0)
-ThermalTake SilentBoost HFS - lapped- with ASV
-Mirror at the bottom of case
-Rheostat to control the 120mm intake and 92mm exhaust
(12v)
-3/4" nose propellor on intake
3DMark03 score: 10844
|
